Setting Up Imotion Vta - iMotion VTA Guia Del Usuario

SETTING UP iMOTION VTA

To set up iMotion VTA
1. Connect the power supply to the AC connector and plug it into
the mains.
OR
Insert 4 x AA batteries in the battery compartment.
2. Insert 2 x AA batteries in the remote control.
3. Turn the on/off switch (located in the rear of the unit) to "on" position.
Keep the on/off switch in an "on" position , unless moving the unit from
place to place.
4. Remove the remote control.
Ensure that there is a direct line of vision between the remote control
signal sender and the remote control sensor.
5. Raise the two handles to the upright position.
6. Connect the headphones to the connector located at the left side of the
device (figure1-3)
12
User Guide
Connector for the
headphones
Setting Up I-Motion VTA