To Turn Off Gas To Appliance - Desa Hearth Products GA9200 Serie Manual De Instrucciones

inStAllAtiOn
Continued
PILOT FLOW AdjUSTmENT
After installation is complete and the unit has
been ignited, it may be necessary to adjust
the pilot. Use a small flat-head screwdriver to
turn the flow adjustment screw on the manual
control valve (see Figure 11). Turn the screw
counterclockwise to allow more gas to flow or
clockwise to restrict gas flow. Be careful to limit
the turns to 2 / from the fully closed position.
1
2
Further turning can result in gas leaking at the
adjustment screw and the pilot flame size will
diminish. The proper pilot flow will result in a
strong blue flame between 1/2" and 1" long.
Pilot Flow
Adjustment
Screw
Figure 11 - Pilot Flow Adjustment Screw
OPerAtinG APPliAnce
OPERATING INSTRUCTIONS
FOR GA9200 SERIES
1. STOP! Read the safety information,
in the owner's manual included with
your hearth kit.
2. make sure equipment shutoff valve
is fully open.
3. Press in and turn control knob clock-
wise to the OFF position.
4. Wait five (5) minutes to clear out any gas.
Then smell for gas around log set and
near floor. If you smell gas, STOP! See
Safety information and Air For Combus-
tion And Ventilation, in your hearth kit
owner's manual. If you don't smell gas,
go to the next step.
5. Turn control knob counterclockwise
to the PILOT position and press in.
Keep control knob pressed in for five (5)
seconds.
Note: you may be running this log set
for the first time after hooking up to
gas supply. If so, the control knob may
need to be pressed in for 30 seconds or
more. This will allow air to bleed from
the gas system.
117422-01C
6. With control knob pressed in, push
down and release ignitor button. This
will light pilot. The pilot is attached to
the rear of the front burner. If needed,
keep pressing ignitor button until pilot
lights.
Note: If pilot does not stay lit, contact
a qualified service person or gas sup-
plier for repairs. Until repairs are made,
light pilot with match.
7. Keep control knob pressed in for 30
seconds after lighting pilot. After 30
seconds, release control knob.
Note: If pilot goes out, repeat steps 3
through 7.
If control knob does not pop up when
released, contact a qualified service
person or gas supplier for repairs.
8. Turn control knob counterclockwise
light. If burner does not light, call a
qualified service person.
9. To leave pilot lit and shut off burners
only, turn control knob clockwise
Note: Follow the Troubleshooting sec-
tion in the owner's manual included
with your hearth kit.
Figure 10 - Ignitor and Control Knob
Pilot
Figure 11 - Thermocouple and Pilot
1. Turn control knob clockwise
the PILOT position.
2. Press in and turn control clockwise
3. Close equipment shutoff valve (see
Figure 4, page 5).
www.desatech.com
to the ON position. Burner should
to the PILOT position.
Control Knob
Ignitor
ON
FROM "PILOT" POSITION
On
TO TURN OFF GAS
TO APPLIANCE
to the OFF position.
Pilot
OFF
SLIGHT PUSH TO
Off
TURN OFF
PULL PUSH
TO LIGHT
Thermocouple
to
7