Charging Procedure - Revell Control OUT SPEEDER 3965 Manual Del Usuario

Carrito con radiocontrol
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Attention: • Allow the battery to cool off for 10-15 minutes before recharging.
• Be sure the car is switched OFF before starting to charge!
• Do not leave the battery unattended during the charging process.
Getting Started:
tting Started:
Operation:
The car moves forward if the
forward button is pressed
and moves backward if the
backward button is pressed.
1. Switch off the car!
2. Carefully connect the USB cable to the car.
3. Connect the other end of the USB cable to a PC.
4. The charging process takes approximately 20 minutes. The USB cable lights up red after the battery
is completely charged. For safety reasons never charge the battery for longer than 20 minutes.
5. Disconnect the USB cable from the PC and the car.
1. Extend the antenna
1. Extend the antenna on the controller.
3. The signal indicator on the controller lights
up as soon as a button is actuated.
The car moves forward at
maximum speed when the
turbo button is pressed.

Charging Procedure

• The car can be driven for approximately 20 minutes
following a charge time of 20 minutes.
Driving the Vehicle
2. Switch the car to ON.
The car turns as the right/left button is pressed.
The steering trim of the
car can be corrected with
the wheel alignment lever.
3

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Out speeder 3967

Tabla de contenido