Charging Procedure; Getting Started - Revell Control BEASTIE BUG Manual Del Usuario

Attention: • Allow the battery to cool off for 10-15 minutes before recharging.
1. Switch off the car.
2. Carefully connect the battery to the peak
detection unit.
3. Plug the other end of the charger into an AC wall
outlet.

Getting Started:

Operation:
• To slowly drive forward, pull the trigger slightly. To drive
faster, pull the trigger further.
• To brake, push the trigger. To drive in reverse, push again.
• During a crash, release the trigger.
• Do not leave the battery unattended during the charging process.
• The vehicle can be driven for approximately 6 minutes following a charge time of approximately 2 hours.
• Charge times will vary depending on how much charge is left in the battery.
4. The charging process takes approximately 2
hours. For safety reasons, never charge the battery
for longer than 2 hours. While charging, the peak
detection unit LED will be on. When the battery is
fi nished charging, the LED will be off.
1. Turn the controller on by
pressing the button.
To turn the controller off,
press and hold the button
until the blue light turns off.
• When the vehicle battery becomes low, the vehicle will roll to a stop and the motor will begin beeping.
• Allow the battery to cool before recharging.

Charging Procedure

Driving the Vehicle
• To turn, rotate the wheel to the left or right.
• Always move the controls slowly and with a gentle touch.
5. Disconnect the battery from the charger and
reconnect the battery to the speed control.
2. Switch the vehicle to ON.
The ESC will «BEEP» 4 times
if the controller is not on.
3