Service Parts - Broan QTR Serie Manual De Instrucciones

INSTALL GRILLE
5. Finish ceiling.
Install ceiling material. Cut out around housing.
6. Attach
grille to
housing.
Squeeze grille
springs and
insert them
into slots on
each side of
housing.
7. Push
grille
against
ceiling.
8. Remove
light lens.
Carefully
insert a small
flat-blade
screwdriver
betweeen
grille and lens.
Pry lens out.
9. Install light
bulbs.
Fluorescent
bulb supplied
with "FLT"
models.
Purchase an
incandescent
bulb for "L"
Fluorescent bulb shown
models - 100W
Max.
Purchase a 4W incandescent night light bulb.
Insert bulbs into their sockets. Replace lens.
MODELS QTR080L • QTRE080FLT •

SERVICE PARTS

Key No. Part No.
1 97016466 Housing
2 97016449 Duct Connector-4"
3 98010102 Wiring Plate
4 99170245 Screw, #8-18 X .375 (2 req'd)
5 97016933 Wire Panel/Harness Assembly
6 99020284 Blower Wheel
7 99080568 Motor (QTR080L)
99080562 Motor (QTRE080FLT)
99080582 Motor (QTR110L)
99080580 Motor (QTRE110FLT)
8 99100491 Isolator (4 req'd)
9 97016467 Motor Plate (QTR080L, QTR110L)
97016901 Motor Plate (QTRE080FLT, QTRE110FLT)
10 99250959 Washer #8 (4 req'd)
11 99260558 Nut, Hex Lock #8-32 (4 req'd)
* 97016621 Blower Assembly (QTR080L)
* 97016905 Blower Assembly (QTRE080FLT)
* 97016739 Blower Assembly (QTR110L)
* 97016906 Blower Assembly (QTRE110FLT)
12 97016546 Grille Assembly (QTR080L, QTR110L)
97016868 Grille Assembly (QTRE080FLT, QTRE110FLT)
13 99140199 Grille Spring (2 req'd)
14 99111281 Lens
15 97016888 Bulb, 42W Fluorescent (QTRE080FLT, QTRE110FLT)
16 97016864 Ballast Assembly (QTRE080FLT, QTRE110FLT)
17 99260423 Nut, Hex #8-32 (2 req'd) (QTRE080FLT, QTRE110FLT)
18 99111293 Spacer (2 supplied)
19 QTHB1 Hanger Bar Kit
Order service parts by "Part No." - not by "Key No."
QTR110L • QTRE110FLT
TAB
Description
(includes key nos. 6 thru 11)
(includes key nos. 13 & 14)
Page 4
Replacement parts can
be ordered on our
website. Please visit us
at www.broan.com
SERVICE NOTE
To remove Blower
Assembly:
Unplug motor (7).
Remove screw (4) from
motor plate (9) flange.
Find the single TAB on
the motor plate (located
next to the receptacle).
Push up near motor plate
tab while pushing out on
side of housing. Or insert
a straight-blade
screwdriver into slot in
housing (next to tab) and
twist screwdriver.
99043845A