Publicidad
Step 9
Lay the BACK (X) over your unit.
å
Make equal margins along all four edges of the BACK (X).
å
Push on opposite corners of your unit if needed to make
it "square".
Fasten the BACK (X) to your unit using the NAILS (1N).
å
NOTE: Be sure to tap NAILS into the holes that line up
å
over the UPRIGHTS (D).
NOTE: Perforations have been provided for access
å
through the BACK. Carefully cut out the holes needed.
Using your hammer, tap four TACK GLIDES (12E) into the
å
bottom edges of the ENDS (A and B).
A
12E
www.sauder.com/service
The perforations
must be here.
413852
Caution
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
NAIL
(30 used in this step)
These holes must line up
over the UPRIGHTS (D).
X
B
1N
Page 13
Publicidad
