Before Use; Product Assembly - cecotec READY WARM 3500 CURVED FLAMES Manual De Instrucciones

ENGLISH

3. BEFORE USE

• Take the product out of the box.
• Remove all packaging materials. Keep the original box.
• Leave a minimum distance of 30 cm between the bottom of the device and the floor.
• Leave a minimum distance of 100 cm between the top of the device and the ceiling.
• Make sure all the components are included and in good conditions, otherwise, contact
immediately the official Technical Support Service of Cecotec.
NOTE: The device will automatically switch off when the temperature suddenly decreases
between 5 and 10 ºC.

4. PRODUCT ASSEMBLY

Wall installation
A distance of at least 60 cm is recommended from the bottom of the heater to the floor for an
optimum visual effect.
1. The wall bracket is fixed to the back of the device. Unscrew it from the back of the device
before fixing.
2. Select the mounting place and draw a horizontal line using a leveling ruler, marking the 4
holes where the mounting bracket will be hung.
1
3. Drill 4 holes with a thickness of 8 mm and a depth of 26 mm in the 4 marks of the previous
point. Insert the expansion screws in the holes until they're at level with the wall.
4. Screw the wall bracket onto the wall with the 4 screws provided. Make sure it is properly
fixed onto the wall.
36 READY WARM 3500 CURVED FLAMES
2