Features; Assembly & Operating - Surtek MH600 Manual De Usuario Y Garantía

jury to the operator. Never touch a saw blade
immediately after using the tool. The blade
will be extremely hot and will burn your hand.
Only use accessories designed for use with this
tool.

FEATURES

KNOW YOUR TOOL
Before attempting to use this product, become
familiar with all of its operating features and
safety requirements.
1. ON/OFF SWITCH.
2. SPEED CONTROL WHEEL.
3. ACCESSORY HOLDER.
4. AIR VENTS.
ACCESSORIES
WARNING: Use only accessories that are
recommended for this multi-tool. Follow the
instructions that accompany the accessories.
The use of improper accessories may result in
injury to the operator or damage to the tool.
Before using any accessory, carefully read the
instructions or the owner's manual for the ac-
cessory.
• Saw blades
• Scraper blades
• Sandpaper
WARNING: If any part is missing or dam-
aged, do not plug the tool into the power
source or install any accessory until the missing
or damaged part is replaced.
CONTENTS
Carefully unpack the multi-tool. Compare the
contents against the "MULTI-TOOL COMPO-
NENTS" chart below.
NOTE: See illustration of the multi-tool.
12
2
1
4
3
WARNING: To avoid fire or toxic reaction,
never use gasoline, naphtha, acetone, lacquer
thinner or similar highly volatile solvents to
clean the tool.
ASSEMBLY AND OPERATING
All accessories are installed on the multi-tool in
a similar manner. For the purposes of describ-
ing the accessory installation, the half circle
blade is used.
DANGER: Always remove the plug from
the power source before installing or remov-
ing accessories or sandpaper. Failing to remove
the plug from the power source may result in
the tool accidentally being started and causing
serious injury to the operator.
1. Remove the screw (1)
and washer (2) from the
accessory holder (3) by
turning the screw counter
clockwise. Use the 5 mm
Hex key (4) if the screw is
too tight to be removed
by hand (Fig. 1).
2. Place the blade (5) on
the accessory holder (Fig.
2).
NOTES:
a) Make sure the alignment holes (6) in the
blade fit over the alignment pins (7) in the
accessory holder and the printed side of the
blade is facing the tool.
b) The blade can be mounted at various angles
left or right of center if required.
3. Thread the screw (1) through the washer (2)
and the blade and into the accessory holder
threaded hole (8).
4. Turn the screw clockwise until it is finger
tight.
NOTES:
a) Check to make sure the convex curve of the
washer (9) is facing the head of the screw.
b) Make sure the alignment holes in the blade
are still mated with the alignment pins in the
accessory holder.
5. Firmly tighten the screw with the 5 mm hex
key.
Fig.1
Fig.2