Surtek MH600 Manual De Usuario Y Garantía página 13

NOTE: Check to make sure the holes in the
blade are still mated with the alignment pins
on the accessory holder after the crew is fully
tightened.
INSTALLING SANDPAPER
1. Install the hook & loop
sanding pad (1) onto the
tool (Fig. 3).
2. Firmly press the sand-
paper (2) onto the hook &
loop pad.
NOTES:
a) Place the sandpaper so the holes in the sand-
paper line up with the matching holes in the
hook & loop pad.
b) Press the sandpaper
firmly onto the hook &
loop pad.
3. To remove the sandpa-
per, simply peel the sand-
paper way from the hook
& loop pad (Fig. 4).
ON/OFF SWITCH
1. To turn the tool ON,
slide the ON/OFF switch
(1) toward the front of the
tool (Fig. 5).
2. To turn the tool OFF,
slide the ON/OFF switch
toward the rear of the
tool.
SPEED CONTROL WHEEL
The speed of the tool can be adjusted to run
the tool at speeds varying between 10,000
OPM and 18,000 OPM by rotating the speed
control wheel (1) located toward the rear of
the tool housing (Fig. 6).
1. To in crease the speed,
rotate the speed control
wheel toward the left side
of the tool.
2. To decrease the speed, rotate the speed con-
trol wheel toward the right side of the tool.
NOTE: Speed #1 is the lowest speed. MAX is the
highest speed.
The optimal speed setting will vary depending
upon the type of accessory being used, the sur-
face being worked and the complexity of the
Fig.3
Fig.4
Fig.5
Fig.6
E N G L I S H •
project. For general recommendations, see the
chart below.
PROJECT ACCESSORY
Drywall Half cirlce blade
Restoring
Half cirlce blade
windows
Door jamb Wood blade
Door casing Wood blade
Wood dowels Wood blade
Floor vent Wood blade
PVC Pipe Wood blade
Glued flooring Scraper
Sanding Sander
WARNING: For safety reasons, the operator
must read the sections of this Owner's Manual
entitled "GENERAL SAFETY WARNINGS", "
POWER TOOL SAFETY", " SPECIFIC SAFETY
RULES" and "SYMBOLS" before using this
multi-tool.
Verify the following every time the multi-tool
is used:
1. Safety glasses, safety goggles, or face shield
are being worn.
2. Hearing protection is being worn.
3. The blade or sandpaper is In good condition.
4. The accessory is properly tightened into the
accessory holder of the tool.
Failure to observe these safety rules will signifi-
cantly increase the risk of injury.
FLUSH CUTTING A DOOR JAMB AND CASING
FOR INSTALLING FLOORING
The multi-tool can be used lo flush cut a door
jamb and casing lo allow space for the new
flooring to fit neatly under the door jamb and
casing. For the purpose or demonstrating the
procedure, floor tile is being used.
1. Install the plunge cut-
ting wood saw blade for
wood in the tool (Fig. 2).
NOTE: The blade should
be centred on the tool
housing and NOT installed
in the 90° position.
U se r' s m a nu a l
SPEED
Maximum
Medium
Maximum
Med/ Max
Maximum
Med/ Max
Medium
Medium
Med/ Max
Fig.7
13