Motor Settings; Maintenance And Cleaning Instructions - World Dryer SMARTdri K48 Serie Manual De Usario

The adjustable dryer controls are located on the printed circuit board inside the dryer's wiring compartment.
To adjust dryer controls:
1. Disconnect the power source.
2. Use the security hex key supplied to turn the cover mounting screws clockwise to remove the cover from the dryer.
3. Remove the wiring compartment cover to access the adjustable controls (see Fig. 1).
4. Adjust motor setting and heater as desired, and replace wiring compartment cover.
5. Reassemble the dryer cover using the security hex key supplied to turn the cover mounting screws counter-clockwise
and tighten until snug. Do not over tighten.

Maintenance and Cleaning Instructions

IMPORTANT: Excessive lint and dust build up inside the dryer can damage the motor and heating element.
Excessive build up can also increase the dryer's air temperature and risk injury to users. With light to moderate
wash room traffic, cleaning the hand dryer once a year will keep it in good operating condition. If the washroom
traffic is high, the dryer should be cleaned every 6 months. Read complete instruction before proceeding.
1. Disconnect the power source.
2. Use the security hex key supplied to turn the cover mounting screws clockwise to remove the cover from the dryer
3. Remove any lint or dust from the dryer base using a vacuum. Use caution to not damage wires or circuit boards.
4. For hand dryer models with an open cell filter covering the air intake, remove filter by gently lifting the filter up and
around the motor inlet cover. Clean the filter with a vacuum, and replace onto the motor inlet cover.
5. Loosen and remove (4) screws from motor inlet cover, and remove motor inlet cover to access the motor and the motor
housing for cleaning.
6. Use soft-medium bristle ½" paint brush to clean lint, dust and dirt from motor. Eliminate any build up of lint and dust
from the interior of the motor housing using a brush and/or vacuum.
7. After completing the cleaning process, completely reassemble the motor and motor inlet cover.
8. Reassemble the dryer cover using the security hex key supplied to turn the cover mounting screws counter-clockwise
and tighten until snug. Do not over tighten.

Motor Settings

Hi / Med / Low
6
Fig. 1
Heater Options
On / Off