Tabla De Contenido; Tools Needed For Assembly - PEERLESS Paramount PP740 Instalación Y Ensamblaje

NOTE: Read entire instruction sheet before you start installation and assembly.
• Do not begin to install your Peerless product until you have read and understood the instructions and warnings
contained in this Installation Sheet. If you have any questions regarding any of the instructions or warnings, please
call Peerless customer care at 1-800-865-2112.
• This product should only be installed by someone of good mechanical aptitude, has experience with basic building
construction, and fully understands these instructions.
• Make sure that the supporting surface will safely support the combined load of the equipment and all attached hard-
ware and components.
• Never exceed the Maximum UL Load Capacity. See page one.
• If mounting to wood wall studs, make sure that mounting screws are anchored into the center of the studs. Use of an
"edge to edge" stud finder is highly recommended.
• Always use an assistant or mechanical lifting equipment to safely lift and position equipment.
• Tighten screws firmly, but do not overtighten. Overtightening can damage the items, greatly reducing their holding
power.
• This product was designed and intended to be mounted to the following supporting surfaces checked below with the
hardware included in this product as specified in the installation sheet. To mount this product to an alternative support-
ing surface, contact Peerless customer care at 1-800-865-2112.
• This product was designed to be installed on the following wall construction only;
WALL CONSTRUCTION
x Wood Stud
x Wood Beam
x Solid Concrete
x Cinder Block
Metal Stud
Brick
Other or unsure?

Tools Needed for Assembly

• stud finder ("edge to edge" stud finder is recommended)
• phillips screwdriver
• 3/16" allen wrench
• drill with 1/4" and 5/32" drill bits
Table of Contents
Parts List .............................................................................................................................................................................. 3
Installation to Wood Stud Wall ............................................................................................................................................. 4
Installation to Solid Concrete and Cinder Block .................................................................................................................... 5
Attaching Adapter Plate to Screen with VESA
Installing to Peerless LC or PLP Model Adapter Bracket ...................................................................................................... 8
Cord Management and Arm Tension Adjustment ................................................................................................................ 10
For customer care call (800) 865-2112 or (708) 865-8870.
Visit Peerless website at www.peerlessmounts.com
WARNING
ADDITIONAL HARDWARE REQUIRED
None
None
None
None
Do not attach except with Peerless accessory kit for metal studs;
Contact Customer Service for Peerless accessory kit for metal studs.
Contact Customer Service
Contact Customer Service
Accessories
• Metal Stud Wall Plate (WSP 490) - required to attach
mount to metal studs (Not evaluated by UL)
Mounting Pattern ........................................................................................ 6
®
2 of 30
ISSUED: 01-15-08 SHEET #: 095-9282-1
For customer care call 1-800-729-0307 or 708-865-8870