Thank you for purchasing this Price Pfister product. All Price Pfister products are carefully engineered, and factory tested to
provide long trouble-free use under normal conditions. This product is easy to install using basic tools and our easy to follow
illustrated instructions. If you have any questions regarding this product, call 1-800-Pfaucet (1-800-732-8238).
1 BEFORE PROCEEDING
WARNING: Read all the instructions completely before proceeding. Price Pfister
recommends calling a professional if you are uncertain about installing this product!
This product should be installed in accordance with all local and state plumbing and
building codes.
2
2 SHUT OFF WATER SUPPLY
Locate water supply inlets and shut off the water supply valves. These are usually found
under the sink or near the water meter. If you are replacing an existing faucet, remove
the old faucet from the sink and clean the sink surface thoroughly.
3
3 TOOLS RECOMMENDED
• PTFE Plumber's tape
• Plumber's putty
• Adjustable wrench
• Pliers
• Cloth
Your installation may require new supply lines and / or shut-off valves or other additional
tools.
4
E
B
4 CHECKING THE CONTENTS OF THE BOX
Upon opening the box, check to ensure that all of the following items are included.
A Spout Body
B Pop-Up Assembly
D Long Nut
E Mounting Washer
G Deckplate
H Putty Plate
If any of these items are missing, please contact Price Pfister Consumer Service at
1-800-Pfaucet (1-800-732-8238).
• Slotted screwdriver
• Flashlight
A
D
F
G
C
H
C Pop-Up Rod
F Seal Base
ENGLISH
FAUCET INSTALLATION
5
BOTTOM GROOVE
5 INSTALLING FAUCET WITH SINGLE HOLE MOUNTING
Following manufacturer's recommendations on use, apply plumber's putty into putty
groove in bottom of Seal Base (5A). Ensure that Seal Base (5A) is pressed onto Spout
Base (5B). Place Seal Base (5A) onto the bottom of Spout Base (5B). From above
sink, insert Faucet Supply Tubes (5C) through Hole (5D) on sink.
6
BOTTOM GROOVE
6 INSTALLING FAUCET WITH DECKPLATE
Ensure that the Plastic Putty Plate (6A) is pressed on the Deckplate (6B). Place a
bead of plumber's putty in the groove along the outer edge of the Putty Plate (6A).
Assemble Deckplate (6B) and Putty Plate (6A) to Spout Base (6C). With the handle
and spout facing forward, carefully install the Faucet Supply Hoses (6D) through the
Center Hole of sink (6E).
2
5A
5C
6B
6A
6D
5B
5A
5D
6C
6E