Tabla de contenido
Publicidad
Inserting in the DIN rail
Step 1
Removing from the DIN rail
Step 1
Step 2
:
Fit the upper claws of the fastening piece
into the upper profile of the DIN rail.
:
Using a screwdriver, release the lower
claws of the fastening piece.
:
Pull slightly from the equipment,
swinging it over the upper nails.
Step 2
:
Straighten the equipment by pivoting it on
the upper claws of the clamp until the lower
claws fit into the lower profile of the DIN rail.
Step 3
:
Remove fully the equipment by pulling it upwards.
Pertenece a:
ZBP-1
Fecha
Realizado
Vº Bº
Comprobado
08-02-2017
J. F. Gil
INSTALL AND UNINSTALL IN DIN RAIL
Cód. Prod.
Rev.
-
0
Vº Bº
Aprobado
Vº Bº
Archivo
MGZBP10100
Siglas
Hoja
ZBP-1
3/3
Publicidad
Tabla de contenido
