General Instructions - T&S B-0114-01 La Instalación Y Las Instrucciones De Mantenimiento

General Instructions

Installation:
See separate installation instruction for
installation of no.6 into deck.
1. Shut off water supply and drain lines.
Apply teflon tape or pipe joint
compound to threads on both ends of
no.5. Screw no.5 into no.6 and
tighten with no.7.
Note: Do not
adjust no.8 in
no.4. If unit is
too high, a new,
shorter no.5
pipe should be
ordered from
T&S.
2. Remove no.7 (do not
remove grease from
parts) and place no.3
on top of no.5.
3. Screw no.10 onto no.3
and tighten with a
wrench.
4. For attachment of no.2 and no.3.
Screw no.9 onto threaded end of no.3
and tighten with a wrench.
7
5
1
4
8
5. Turn on water supply and check for
leaks.
Optional Wall Bracket
T&S 6
BRASS
Note: T&S highly recommends
installing a B-0109-01 Wall Bracket
with these Pre-Rinse Units (included
with the B-0114-01B and the B-2362
units). It must be ordered separately
3
with other models.
The B-109-01 Wall Bracket should be
installed after entire unit is assembled.
10
Fit bracket on no.5 as high as possible.
5
Cut off any excess nipple as needed, and
mount to wall.
Screws
4
3
9
2
Note: Before
tightening no.9.
Check position of
no.1. Handle
should face front
towards the
operator.
Clamp
Nipple