Important; Installing The Hanger Ball/Downrod Assembly - Emerson PRO Serie II Manual Del Usuario

Your ceiling fan is designed to be installed either in the standard manner, or in the
close-to-the-ceiling manner. Using the standard method, the hanger ball/downrod assembly will suspend
the fan several inches below the ceiling cover. Using the close-to-the-ceiling method, the ceiling cover
installs directly on the fan motor housing, thus mounting the fan 3-1/2 inches closer to the ceiling than the
standard method. In no case should the fan blades be lower than seven feet above the floor. Depending
on your desired mounting method, proceed to "INSTALLING HANGER BALL/DOWNROD ASSEMBLY" for
standard mounting, or to "INSTALLING CEILING COVER ON FAN MOTOR HOUSING" for close-to-the-
ceiling mounting.

3. Installing the Hanger Ball/Downrod Assembly

3.1
Pass the 42" motor leads through the opening in the
ceiling cover.
Be sure the cover is oriented correctly (Figure 1).
3.2
Separate, untwist and unkink the three motor leads.
Route the motor leads through the hanger ball/downrod
assembly (Figure 2).

IMPORTANT

(For Standard Mounting)
Figure 1
Figure 2
5
Please contact 1-800-654-3545 for further assistance
U.L. Model No.: 42-ANT & 52-ANT
THREE 42"
MOTOR LEADS
CEILING
COVER
THREE 42"
MOTOR LEADS
HANGER
BALL/3.5"
DOWNROD
ASSEMBLY
emersonfans.com