Emerson PRO Serie II Manual Del Usuario página 9

4. Installing the Ceiling Cover on the Fan Motor
Housing
4.3
Gently pry the decorative cap from the ceiling cover
(Figure 8).
4.4
Align the holes in the ceiling cover with the holes in the
motor housing and secure using the three screws
previously removed in Step 4.1 (Figure 9).
NOTE: For hanging instructions using Close-to-the-
Ceiling Method, See Page 12, Section 7. Hanging
the Ceiling Fan (Close-to-the-Ceiling Method with
Ceiling Cover Installed on the Motor Housing).
4.5
The fan comes with blue, black and white leads that are
42" long.
Measure up approximately 6 to 9-inches above the
motor coupling (Figure 10).
Cut off excess leads and strip back insulation 1/2-inch
from ends of leads.
(For Close-to-the-Ceiling Mounting) (Continued)
DECORATIVE CAP
CEILING COVER
Figure 8
SCREWS (3)
(Previously Removed)
CEILING COVER
RUBBER GASKET
Figure 9
MOTOR
COUPLING
Figure 10
Please contact 1-800-654-3545 for further assistance
9
6 TO 9
INCHES
emersonfans.com
U.L. Model No.: 42-ANT & 52-ANT