Tabla de contenido
Publicidad
SECTION C: APPLY HEIGHT AND MOVING LABEL & SECURING SYSTEM
Carefully upright assembly. Apply moving system label (23) to front of pole as shown. Regulation
1.
rim height is 10 feet (3.05 m).
23
2.
Place assembled unit in desired location. Fill tank with
water (30 gallons/114 liters) or sand (300 lb./136 kg)
and snap tank cap (4) in place.
HEIGHT ADJUSTMENT
TO ADJUST BACKBOARD:
1. TO RAISE BACKBOARD:
Slowly push up on the rim
with
broom
handle or wooden dowel,
3/4"- 7/8" (19mm - 22mm) diameter
as shown to engage locking
mechanism at desired height.
2. TO LOWER BACKBOARD:
Push lever up to unlock and
carefully lower backboard to lowest
position.
10 ft.
MOVING SYSTEM
(3.05 m)
1
2
3
4
NOTE:
Peel protective
film from surface
of acrylic
backboard prior
to use.
23
LEVER
1
2
BROOM
HANDLE
1. Adjust basketball backboard
height to lowest position.
2. While holding pole, rotate
basketball system forward
until wheels engage with
ground.
3. Move basketball system to
desired location.
4. Carefully rotate basketball
system upright.
5. Reattach ground restraint and
check system for stability.
201257
3/99
23
WARNING!
TWO PEOPLE REQUIRED FOR
THIS PROCEDURE. FAILURE
TO FOLLOW THIS WARNING
COULD RESULT IN SERIOUS
INJURY AND/OR PROPERTY
DAMAGE.
WARNING!
DO NOT LEAVE ASSEMBLY
UNATTENDED WHEN EMPTY; IT
MAY TIP OVER.
WARNING!
DO NOT ALLOW CHILDREN TO
ADJUST HEIGHT.
CAUTION!
ADD TWO GALLONS (7.6
LITERS) OF NON-TOXIC
ANTIFREEZE IN
SUB-FREEZING CLIMATES.
NOTE:
IF USING SAND: 2 GALLONS
OF ANTI-FREEZE IS NOT
REQUIRED
4
4
04/06
ID# M7301241
Publicidad
Tabla de contenido
