Mopar RAM BOX Manual De Usario

1. Installation Preparation – Verify kit contents
DODGE RAM UNDER RAIL BEDLINER
Description
Under Rail Bedliner
Tailgate Cover
Installation Kit
READ ALL INSTRUCTIONS THOROUGHLY BEFORE
STARTING. Improper installation may void warranty.
The manufacturer recommends using two people;
however bedliner can be installed by one person.
2. Tailgate Cover Installation
September 8, 2015
RAM BOX UNDER RAIL BEDLINER KIT
Qty. Kit Contents:
2 self-tapping screws,
1
12 cap plugs,
1
Installation instructions
1
sheet
Tools Required:

PHILLIPS SCREW DRIVER
(For securing screws)

#30 TORX DRIVER
(For installing tailgate cover)

10MM SOCKET WRENCH
(For hex bolts in cargo management rails)

PORTABLE DRILL W/T20 TORX DRIVER
(For installing self-tapping screws)

TORQUE WRENCH

DE-BURRING TOOL
CLEANING:
Clean truck box and ensure floor drains (if applicable)
are clear to ensure ventilation and moisture drainage.
STEP 1 (FIGURE #1)
FIGURE #1
Using a #30 torx driver, remove and save eight (8)
screws from truck tailgate. Remove only the
screws
configurations.
(NOTE: Do not remove metal cover that is held
down by these 8 screws.)
FIGURE #2
STEP 2 (FIGURE #2)
Center the tailgate cover on the truck tailgate.
Press the cover down and forward into place. Line
up holes in tailgate cover with holes in truck
tailgate.
FIGURE #3
STEP 3 (FIGURE #3 & FIGURE #4)
Use the eight (8) screws, removed in Step 1, to
fasten the tailgate cover to the tailgate with #30
FIGURE #4
Torx Driver.
Torque specifications: 62 in lb +/- 4.4 in lb
(7 Nm +/- 0.5 Nm)
DO NOT USE POWER TOOLS.
indicated by "X"
1
www.mopar.com
for all tailgate
590053 Rev. 7
K6862360 Rev. 2