Setting The Switching Point And Mounting The Switch - Abicor Binzel CAT3 PRO Manual De Instrucciones

1 Replacing the switch

1.3 Setting the switching point and mounting the switch

NOTICE
• Spare part set 780.2190.1 is required to replace the switch.
• In general, we recommend use of the spring changing device 780.2093.1.
Use of a suitable device makes alignment and assembly significantly easier.
• A multimeter is needed for alignment and assembly tasks.
With device
BN (brown)
EN - 6
Z direction
WH (white)
Switch Replacement for CAT3 PRO
1 Place CAT3 PRO in the device.
2 Deflect CAT3 PRO in the Z direction
1.10 mm (± 0.1 mm) using a suitable
device.
One rotation of the clamp lever in the
Z direction equals 1.5 mm deflection
(pitch of threaded spindle on clamping
lever = 1.5 mm).
3 Use the multimeter to perform the
continuity check on PIN2 (BN) and PIN3
(WH) on the CAT3 PRO flange plug.
BEI.0369.0 • 2021-02-16