Omnifilter F1 Instrucciones De Instalación

293 Wright St. • Delavan, WI 53115
Phone: 800.937.6664
www.omnifilter.com
Precautions
NOTE: The system and installation must comply with all state and local
laws and regulations.
WARNING
Do not use with water that is microbiologically unsafe
or of unknown quality without adequate disinfection before or after
the system.
oPerating sPecifications
Pressure Range: 25–125 psi (1.72–8.6 bar)
Temperature Range: 40°F–100°F (4.4°C–37.8°C)
(cold water use only)
Replacement Filter FRC1-D
Cartridge (set of 2):
instructions for installation
Do not allow filter to freeze; do not expose filter assembly to direct
sunlight (ultraviolet light).
1.
Remove your faucet aerator.
2. Attach the water filter to your faucet. You may need to use one of
the adapters supplied with the filter. If an adapter is used, be sure
to also use the appropriate washer between the faucet and adapter
(Figure 1).
3.
Turn on the cold water and set the selector knob to "FILTERED"
(Figure 2). Flush the filter for 1 or 2 minutes to remove any loose
carbon. Return the selector knob to "UNFILTERED."
NOTE: DO NOT ruN hOT waTEr ThrOugh ThE filTEr. Damage
may occur and cause the filter to leak or malfunction.
4. Set the date on the selector knob ahead 3 months (Figure 3). The
filter should be changed after 200 gallons or every 3 months. The
filter life will depend on your individual water conditions and may
need to be changed sooner. If bad taste and odor return it is time
to change the filter.
NOTE: For best results operate the filter in the UNFILTERED position
except when filtered water is needed for drinking, cooking or
making ice.
For further operating, installation, maintenance, parts or assistance:
Call OMNIFILTER Customer Service at 800.937.6664
©2009 OMNIFILTER
Faucet Water Filter
INSTALLATION INSTRUCTIONS
1
2
3
CHANGE
FILTER
Model F1
CHANGE
JAN
FILTER
CHANGE
JAN
FILTER
JAN