Pressalit Care RK1010 Funcionamiento Y Mantenimiento página 17

Service inspection
We recommend that a service inspection is performed once
annually.
Wall-mounted
1. Run the lift unit up/down to check that:
a. there are no visual defects or abnormal noise.
b. the product runs up/down satisfactorily.
If there are no visible defects or abnormal noises coming
from the moving parts, no further action is required.
If a telescopic leg is defective, it must be replaced.
(Contact your dealer for replacement).
2. Check the wall brackets and tighten if necessary. If the
brackets need tightening, raise the worktop to maximum
height. Support the worktop with its longitudinal profi le,
and remove the angle gear and profi le.
worktop. The crank extension rod will hang free.
Insert the crank in the extension rod, wind the worktop
down and remove.
legs, and remove the legs.
Replace the telescopic legs in reverse order, and raise
them. Fit the worktop with its longitudinal profi le
3. Check the supports are correctly fi tted.
4. Check the crank.
replaced. (Contact your dealer for replacement).
Freestanding
1. Run the lift unit up/down to check that:
a. there are no visual defects or abnormal noise.
b. the product runs up/down satisfactorily.
If there are no visible defects or abnormal noises coming
from the moving parts, no further action is required.
If a telescopic leg is defective, it must be replaced.
(Contact your dealer for replacement).
2. Check the legs and tighten if necessary.
3. Check the crank.
replaced. (Contact your dealer for replacement).
Slacken the two screws behind the
34
Tighten wall bracket bolts.
35
If the crank is defective, it must be
39
If the crank is defective, it must be
40
Remove the
32
33
36
37
38
32
33
34
2
35
1
3
36
Manual lift units
1
17