Reset Back To Default Settings; Caution; Main Specifications - HORI nsw 228u Manual De Instrucciones

■ Reset back to default settings

To simultaneously reset all of the following: Quick Handling Mode ・ Dead Zone Adjustment ・ Sensitivity Adjustment.
Press for 3 seconds
When Quick Handling Mode is cancelled, steering wheel input value will default to 270°.
Dead zone and sensitivity default values are set to "4".
・ If you do not perform step
button assignment mode will automatically end.

■ Caution

・ Never disassemble, repair, or modify this product.
・ Keep the controller away from dusty or humid areas.
・ Do not apply strong impact or weight on the product.
・ Do not pull roughly or bend the cable of the controller.
・ If product needs cleaning, use only a soft dry cloth. Do not use any chemical agents like benzine or thinner.
・ Keep this product out of the reach of children under 3.

■ Main Specifications

Steering Unit
External Dimensions： 280 × 275 × 286mm
Steering Diameter ： 280mm
： 1400g
Weight
： 270°
Angle of Rotation
： 3m
Cable Length
8
Press
after , the Program LED (Right) will turn off after four seconds and
Program LED (Right)
will flash (slowly).
Program LED (Left)
will turn off.
(The Program LED (Right) will light green when assigning buttons.)
Foot Pedals
External Dimensions： 234 × 305 × 180mm
： 700g
Weight
： 1.5m
Cable Length
Program LED (Right)
will turn off.