N-Com mcsIII S Serie Manual De Instrucciones página 11

Caution: Always verify the proper length of the chinstrap and adjust it as necessary, once again
referring to the specific helmet instructions.
Fig. 15
3.3. Removing the system
Fig. 16
 After releasing the connector from the shell, also remove the right part by releasing the MCS III
from the shell pins.
 Now remove the entire system from the helmet.
 Reposition the protection plate covering the "N-Com" housing
on the shell. First insert the rear part and then press the front
part until the fastening clasp clicks.
 To remove the system from the helmet, remove the earphone
and the comfort cheek pads as shown in the assembly
operations. Then remove the polystyrene cheek pads.
MCS III
11