N-Com mcsIII S Serie Manual De Instrucciones página 9

Fig. 9
3.2. Installing the system on the helmet
 Position the system inside the helmet as shown in figure 10, next to the N-Com housing in the
shell.
 Looking at the helmet from the outside, slide the rear positioning tab into groove A as shown in
the figure.
 Press in the area marked PUSH from inside the helmet until the fastening clasp B clicks (Fig. 11).
 Place the component with the caption "MCS III" in its position in the gasket of the helmet: the
gasket must be slightly bent to facilitate the insertion (Fig. 12).
Fig. 10
FULL-FACE HELMETS
 Take the polystyrene cheek pad (left-hand side)
and position the microphone in its housing, as
shown in Fig. 9. Make sure that the side of the
microphone support with the writing "N-Com" is
facing inward.
Fig. 11
MCS III
Fig. 12
9