Thank you for using a KABI product!
Read this manual carefully prior to using the pump.
Please forward this manual to all other users, to make
them aware of all warnings and specifications.
Index
Pump components
I. Operating Manual
ll. Maintenance
lll. Troubleshooting Guide
Warning
• Not for use with gasoline or alcohol.
• Not for use in hazardous locations.
• Improper use or installation of this product can
cause serious bodily injury or death.
• Do NOT smoke near the pump or use the pump
near an open flame.
• Do not dispense fluid that is thicker than diesel
fuel.
l. Operating manual
(A) Before using your pump
1. Check that the machine has not suffered any
damage during transport or storage.
2. Clean the inlet and outlet ports, removing any
dust or residual packing material.
3. Check that the electrical specifications correspond
to those shown on the nameplate.
lll. Troubleshooting guide
Problem
Pump fails to prime
Low pumping capacity
KABI Diesel Transfer Pump
(B) While using your pump
1. Select inlet and outlet hoses or pipes compatible
2. Install the strainer provided at the inlet to the
3. Use a nozzle or valve on the end of the discharge
(C) Operating instruction
1. Switch on the pump.
2. Operate the nozzle lever to dispense fluid.
3. When the desired amount of fluid has been
4. The nozzle should be kept clean and dry, and
ll. To maintain your pump
1. Be sure the hose joints have not loosened, to
2. Check the strainer and keep it clean.
3. Keep the pump body clean of any impurities.
4. Do not use the electric power supply cables if
Possible cause
Lack of electric power
Rotor jammed
Motor problems
Obstruction in suction lines
Strainer screen clogged
By-pass valve not seating properly
Low relation speed
2.
with diesel. Tighten fittings securely (inlet/outlet
at pump 3/4" (F)).
suction hose to prevent debris from being drawn
into the pump.
hose that can be shut off tightly to prevent
accidental siphoning when the pump is not in use.
dispensed, release the nozzle lever, remove the
nozzle and switch off the pump.
securely fastened when not in use.
avoid any leakage.
they are not in good condition.
Corrective action
Check the electrical connections
Check for possible damage
or obstruction of the rotating
Contact the service department
Check the tank and inlet hoses
Clean the strainer
Dismantle the valve,
clean or replace it
Check the voltage at the pump,
adjust the voltage and / or use
cables of greater cross-section
components