Setting The Amperage; Control Buttons - Heatworks 1 Manual

SETTING THE AMPERAGE

IMPORTANT: The factory default amperage draw is 15
Amperes. To maximize the amount of temperature rise,
be sure to program your desired amperage to your
specific hot water needs. Also, be sure that your MODEL
1 has been installed and wired to meet the amperage
requirements programmed.
CONTROL END

Control Buttons

CAUTION: Breaker must remain off until installation is complete.
8
Top / Outlet
Inlet / Bottom
STEPS
1) Turn on any hot water faucet.
2) Allow the water to run for 1 minute. Water will not be
hot.
3) Turn on power to the MODEL 1 by turning on the
associated breaker.
4) Press and hold both buttons beside the display screen
of the MODEL 1. (See diagram to the left).
5) Release ONLY the top button.
6) While continuing to hold the bottom button, press and
release the top button five times until the number "5"
appears. The display should start blinking.
IMPORTANT: If the top button is accidentally pressed
more than 5 times, press and release both buttons to
start over.
7) Release both buttons.
www.myheatworks.com