Assembly Instructions - Troy-Bilt TB425CS Manual Del Operador

For TB475SS only: ADJUST THE D-HANDLE
The TB475SS uses a D-handle only, which is pre-
installed on the unit. If you ever need to adjust it, make
sure it is at least 6 inches from the end of the shaft grip
(Fig. 1).
Shaft
Housing
Shaft Grip
Minimum 6 inches
(15.24 cm)
For TB425CS only: INSTALL AND ADJUST
THE J-HANDLE
1. Place the J-handle between the top and middle
clamp pieces (Fig. 2).
(4) Screws
Top Clamp
Middle Clamp
Bottom Clamp
Nuts

ASSEMBLY INSTRUCTIONS

Bottom Clamp
Fig. 1
J-Handle
Fig. 2
2. While holding the three pieces together, install the four
(4) screws through the top clamp and into middle clamp.
NOTE: The holes in the top and middle clamp will line up
only when assembled correctly.
3. Place the clamps and the J-handle over the shaft
housing and onto the bottom clamp.
4. Hold each hex nut in the bottom clamp recess with a
finger. Start screws with a large Phillips screwdriver.
Do not tighten until you make the handle adjustment.
5. Slide the J-handle in or out until the arrow/white line on
the decal touches the clamp assembly (Fig. 3). You must
first loosen the screws if the handle is pre-installed.
Decal
6. While holding the unit in the operating position
(Fig. 27), position the J-handle to the location that
provides you the best grip.
7. Tighten the clamp screws evenly, until the J-handle
is secure.
Fig. 3
7