Funtek DT12 Manual De Usuario página 3

INSTALL TRANSMITTER BATTERIES
1. Remove the battery cover by loosening the screw on the
back of the transmitter with the included screwdriver.
(Figure 1)
2. lnstall 2 x 1.5V AA batteries (not included) in correct
polarities. (Figure 2)
3. Close the battery cover and tighten the screw. (Figure 3)
NOTICE
- When installing batteries, please make sure the battery
polarity is aligned with the battery holder polarity.
- Do not mix new and old batteries,
or batteries of different types
CHARGE AND INSTALL RECHARGEABLE BATTERY PACK
1. Connect the lithium-iron battery pack to the charger
(Figure4), note the charge light turns green.
Insert the charger into the outlet (Figure 5), note the charger
Iight turns red - indicating it's charging.
When charging is completed, charger light turns green again.
Figure 5
3. Connect the sockets of the rechargeable battery packand
the car in correct polarities, then insert the batteryinto the
battery compartment. (Figure 7)
Power Light
Figure 4
Power Switch (Figure 7)
Figure 1
2. Loosen the latches of the battery cover on the bottom of the
car, then removethe battery cover. (Figure 6)
4. Close and secure the battery coverby tightening the latches.
(Figure 8)
- 3 -
Figure 2 Figure 3
Figure 6
Figure 8