Endress+Hauser iTEMP TMT162 Manual De Instrucciones página 66

Menú de configuración y descripción de los parámetros
Expert → Sensor →
1) n = number of sensor inputs (1 and 2)
Expert → Sensor →
Expert → Sensor →
1) n = number of sensor inputs (1 and 2)
Expert → Sensor →
Expert → Output →
66
1)
Sensor n → Sensor type n
Connection type n
2-wire compensation n
Reference junction n
RJ preset value
Sensor offset n
Sensor n lower limit
Sensor n upper limit
Sensor serial number
Sensor n → Sensor trimming→
1)
Sensor n → Linearization→
Diagnostic settings → Sensor switch set point
Drift/difference mode
Drift/difference alarm delay
Drift/difference set point
Controller
Start Value
Calibration countdown
Lower range value
Meas. range end
Failure mode
Error current
Current trimming 4 mA
Current trimming 20 mA
Reset trim
iTEMP TMT162
→  70
→  71
→  71
→  71
→  72
→  76
→  96
→  96
→  96
Sensor trimming →  97
Sensor trimming lower →  97
value
Sensor trimming upper →  98
value
Sensor trimming min span →  98
Reset trim →  98
Call./v. Dusen coeff. R0, A, →  99
B, C
Polynomial coeff. R0, A, B →  99
Sensor n lower limit →  96
Sensor n upper limit →  96
→  77
→  76
→  77
→  77
→  101
→  102
→  102
→  73
→  73
→  78
→  79
→  79
→  79
→  80
Endress+Hauser