Publicidad
Idiomas disponibles
Idiomas disponibles
Propane Torch Kit
Juego de soplete de propano
Notes
Notas
www.chpower.com
10
4. For the WT4500, use flint striker to
ignite torch by creating a spark near
torch nozzle (see Figure 6a). For the
WT5500, press the piezo ignitor
switch near handle (see Figure 6b).
WARNING
!
to ignite torch.
Figure 3 - Hand tightening cylinder
connection
Figure 6a - Using flint lighter
Figure 4 - Tightening cylinder connection
with wrench
Figure 6b - Using piezo ignitor
5. Adjust flame to a minimal level with
torch gas valve.
Torch Use
Figure 5 - Turning gas valve (clockwise
to close, counterclockwise to open)
Point torch at what you want to heat
(WT4500 shown, WT5500 similar)
and pull Turbo Blast Trigger to intensify
the size of the flame (see Figure 7).
Lighting Instructions
Release trigger to bring flame back to
(Cont.)
minimal level.
DO NOT smoke
NOTE: If you have the torch gas valve
WARNING
!
around or expose
open too high, when you pull the
supply tank to open flames or sparks.
Turbo Blast Trigger, the flame will tend
DO NOT apply heat
WARNING
to "blow out" and require reignition.
!
or flame to tank to
On the WT5500, there is an adjustable
check for leaks. Excess heat may cause
the tank to rupture, possibly causing
brass knob used to limit the distance
personal injury.
the Turbo Blast Trigger can move. Turn
3. Slowly open valve on torch about 1/8
the valve clockwise for a smaller flame.
Turn it counterclockwise for a larger
turn until you hear gas flow.
flame. (As a safety precaution, these units
Models WT4500 and WT5500
Do not use matches
or cigarette lighter
Figure 7 - Pulling trigger for flame
turbo blast (WT4500 shown, WT5500
similar)
are equipped with an excess-flow check
valve that shuts off the gas in the event
of a damaged or severed hose. If you
allow the flame to grow too large, the
excess-flow check valve will automatically
shut off gas flow to the torch.)
To extinguish the flame, close the
torch gas flow valve and propane
cylinder valve. Make certain that
torch is completely cooled before
storing. The torch nozzle will be very
hot. Do not touch it or rest it on
anything that can be damaged by heat.
Maintenance
Prior to each use:
1. Inspect all components of the device
for damage and or wear.
If the hose shows
WARNING
!
excessive abrasion
or wear, if the hose is cut, or if it is
more than 5 years old, it must be
replaced prior to operation.
2. Inspect LP gas tank for dents,
damage to collar, damage to shut-off
valve or corroded foot ring.
If dents, damage to
WARNING
!
collar, damage to
shut-off valve or corroded foot ring are
present, the LP gas tank must be
replaced prior to operation.
3. Perform a leak test using soapy water
or leak test solution.
4. Ignite the torch according to lighting
instructions. Check operation of
adjusting valve and all other
components prior to proceeding.
Periodically:
1. Remove any debris or combustible
www.chpower.com
3
Publicidad
