Specifications - Hydraulic Power Source; Pre-Operation; Operation - Burndy PAT644-LI Strucciones De Seguridad, Funcionamiento Y Mantenimiento

6
SPECIFICATIONS - HYDRAULIC
POWER SOURCE
The internal hydraulic power source achieves fluid
pressures in excess of 9,000 lb/in
Do NOT disassemble this tool at any time. Disassembly
of this tool may result in severe personal injury or tool
damage, and will void the warranty.
The hydraulic power system is located internally within
the PATRIOT® and is a non-field serviceable item. If you
suspect that your tool is not functioning properly, please
contact the BURNDY® Tool Service Center at:
1-800-426-8720.
PRE-OPERATION INSTRUCTIONS
Read and follow all PRE-OPERATION and safety
instructions provided for your PATRIOT® and for the
battery charger (see Charger Instruction Manual) and
accessories. Failure to follow the proper operating
instructions and safety information provided can lead to
serious personal injury or death.
Before operating your PATRIOT®, carefully read and follow
these PRE-OPERATION instructions to ensure your tool
is in proper working condition. Read and follow the Battery
Charger Instruction Manual included for operating your
battery charger unit. Following these instructions, charge
the battery(s).
1. Make certain that the latch is closed and the detent pin
is fully engaged on the PAT644-LI.
2. Depress the upper black trigger first to make certain
the tool ram is fully retracted.
3. With a fully charged battery installed in the tool,
depress the lower trigger until the ram of the tool fully
advances. When the crimp is complete you will hear
an audible pop.
2 during normal operation.
Please note that it is not necessary to have a battery
installed in the PATRIOT® in order to retract the tool ram.
To verify that the release valve is functioning properly
advance the tool ram fully and remove the battery from
the PATRIOT® next depress the upper trigger and the
ram should retract.

OPERATION

Read and follow all PRE-OPERATION and
safety instructions provided for your
PATRIOT® and for the battery charger (see
Charger
accessories. Failure to follow the proper
operating
information provided can lead to serious
personal injury or death.
Tools are NOT insulated for use on or near
energized conductors. Use of these tools
near energized conductors may lead to
electrical shock, causing severe injury or
death.
Pinch point hazard. Crimp ram operates at
high speed and force and can cause severe
personal injury. Keep all body parts away
from moving parts of the tool during
operation.
NOTE: Do not immerse the tool in water, as the PATRIOT®
is not designed to operate under water. This is considered
abuse and will void the warranty! Always use the tool
lanyard provided to prevent dropping the PATRIOT®.
1) Read and follow the PRE-OPERATION instructions
and Battery Instruction Manual. Insert a battery into
the tool according to the PRE-OPERATION
instructions.
2) Ensure that ram is fully retracted by depressing the
upper trigger.
3) Slide the appropriate connector over the conductor.
4) Positioning the tool properly on the connector, making
certain that the nest and indenter are aligned over the
crimp area indicators.
5) Depress and hold the lower trigger to advance the tool.
Instruction Manual)
instructions and safety
and