EN
AC Power
Power Linking
AC Plug
Replacing the
Fuse
DMX Linking
DMX Connection
Master/Slave
Connection
This product has an auto-ranging power supply that can work with an input
voltage range of 100 to 240 VAC, 50/60 Hz.
You can link up to 11 COLORdash™ Batten-Hex 8 products at 120 V, 19
products at 208 V, or 20 products at 230 V. Never exceed this number. Power
linking cords can be purchased separately.
Connection
AC Live
AC Neutral
AC Ground
1.
Disconnect this product from power.
2.
Using a flat-head screwdriver, unscrew the fuse holder cap from the
housing.
3.
Remove blown fuse and replace with a good fuse of the same type and
rating.
4.
Screw the fuse holder cap back in place and reconnect power.
The COLORdash™ Batten-Hex 8 will work with a DMX controller using a
regular DMX serial connection. A DMX Primer is available from
www.chauvetpro.com.
The COLORdash™ Batten-Hex 8 uses a regular DMX data connection for its
DMX personalities: 6 Ch, 8 Ch, 12Ch, 13Ch, 48Ch, 53Ch, 68Ch-A,
68Ch-W, 96Ch, HSV, and HSI. See the User Manual to connect and configure
for DMX operation.
Note: For optimum control of the 16-bit dimming channels in the 13Ch,
68Ch-A, 68Ch-W, and 96Ch personalities, be sure that Dim mode is set to Off.
The COLORdash™ Batten-Hex 8 uses the DMX data connection for its
Master/Slave mode. See the User Manual to connect and configure for
master/slave operation.
COLORdash™ Batten-Hex 8 QRG
Wire (U.S.)
Wire (Europe)
Black
White
Green/Yellow
Green/Yellow
3
Screw Color
Brown
Yellow/Brass
Blue
Green
Silver