Krups XP4050 Manual Del Usuario página 11

• Place one or two cups beneath the filter
holder.
As soon as the coffee selection buttons begin
to glow continuously, the machine is ready to
operate.
• Hold down either the one or two cups
button or
coffee button and start/stop switch will
begin to blink.
• When the desired quantity of espresso has
run through, stop the machine by pressing
the coffee button
The quantity that just ran through into your
cup is now automatically programmed into
the machine.
3 . H W P
OT ATER REPARATION
You can prepare hot water with this machine.
• Fill the water container (1) (2) (3) and turn
on the machine (4).
• Place the cup beneath the auto cappuccino
accessory.
As soon as hot water button commences to
glow continuously, the machine is ready to
operate.
• Press the hot water button
• When the desired quantity of water has run
through, stop the machine by pressing again
the hot water button
4. S
TEAM FUNCTION FOR PREPARING CAPPUCCINO
AND LATTE
The thumping noise which occurs while steam
is being produced comes from the intermit-
tent regulation of the pump and has no effect
on the proper working of the machine.
Caution: during and after use of the
machine, the metallic parts of the auto
cappuccino accessory can become
extremly hot.
It is best to use fresh, skim or low-fat, well
chilled milk. The milk container must also be
cold (do not run it under hot water before
frothing the milk).
. Using the Auto Cappuccino accessory
The auto cappuccino accessory makes it easy
to produce steamed frothy milk for making
cappuccino, latte or even hot chocolate.
(9) (10) (>3 sec). The
or (9) (10).
(15).
(15).
• Fill the water container with fresh, cold
water (1) (2) (3) and turn on the machine
(4).
• Put the auto cappucino accessory in place on
the steam nozzle.
• Place a cup under the auto cappuccino
accessory.
• Pour about 100 ml of cold milk into a
container.
• Insert the flexible tube into this container or
directly in the milk (17a).
Please note the straight cut end of tube must
fit inside auto cappuccino device and irregular
end dipped in the milk.
• Turn the setting knob on the auto cappuc-
cino accessory to the position 'cappuccino'
or 'latte'.
• When the machine is ready (start/stop
switch glows continously), press the steam
button (16), and it will begin to blink.
When the steam button glows continuously
again, the machine is now ready for steam.
• Press the steam button
• Once the desired level of froth has been
produced, press the steam button again to
stop (16) .
Follow this cleaning operation in order to
prevent the milk from drying on the auto
cappuccino accessory:
• Place a cup under the auto cappuccino
accessory
• Immerse the flexible tube into a clean
container 1/3 full of water.
• Press the steam button
the water has run through, press the steam
button again (16) to stop.
• Next, clean the auto cappuccino accessory
with a damp cloth. We recommend that
you clean the auto cappuccino accessory
immediately.
For more thorough cleaning of the auto
cappuccino accessory, please refer to the
section below entitled «Cleaning the
machine».
If you wish to make an espresso immediately
after steaming milk, the machine must first be
allowed to cool down in order to achieve the
correct temperature required to prepare an
espresso.
(16).
(16) and when all
11