Troubleshooting - Spectravision Adagio PRO Manual Del Propietário

Troubleshooting

PROBLEM
.
The pool light is flickering
.
Several pool lights in the
pool show different
color programs
1. Switch the lamps ON
For RGB lamps: select the Sun White color program
2. Remove the lamp from the water, unscrew the clips nut,
pull back the gasket and the black cable jacket, so you can
reach the brass contacts inside the connector block
(do not remove the connector block)
3. Measure the voltage at the lamp terminals (while the lamp
is still ON)
4. The voltage at the lamp should be at least 10VAC 50/60hz.
If the measured line voltage is below 10VAC:
A. Check the output voltage at the transformator terminals.
This voltage should be between 12VAC and 14VAC.
Verify that the used transformator VA rating is sufficient
for powering all connected lamps
B. If the transformator output voltage is ok, then install a
thicker cable between the transformator and the lamp.
(wiring instructions p. 8-13)
Make sure that all lamps are connected to the same 12VAC
power line. Execute the synchronization as explained on p.16
SOLUTION
17