Attaching The Light Fixture/Glass Shades - HAMPTON BAY Sibley 52-BRW Manual Del Propietário

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Blade Balancing
All blades are grouped by weight. Because nat-
ural woods vary in density, the fan may wobble
even though the blades are weight matched. The
following procedure should correct most fan
wobble. Check after each step.
1. Check that all blades are securely mounted
to the blade brackets with the locking mech-
anisms engaged.
2. Run the fan for ten minutes. If the fan con-
tinues to wobble please contact Customer
Service and a balacing kit will be sent to you
at no charge.
TO REDUCE THE RISK OF PERSONAL INJURY,
DO NOT BEND THE BLADE HOLDERS WHILE
INSTALLING, BALANCING THE BLADES, OR
CLEANING THE FAN. DO NOT INSERT FOREIGN
OBJECTS BETWEEN ROTATING BLADES.
Attaching the Light
Fixture/Glass Shades
CAUTION - To reduce the risk of electric
shock, disconnect the electrical supply circuit
to the fan before installing the light fixture.
1. Loosen the three serrated head screws on
the switch cup cover of the light kit fitter
(Figure 16).
2. Connect the wires from the light kit fitter
to the wires from the switch cup of the fan
motor assembly by connecting the molded
adaptor plugs together (blue to black, white
to white). Carefully tuck all wires and splic-
es into the switch cup.
3. Align the three serrated head screws on the
switch cup cover of the light kit fitter with
the three key slots in the switch cup. Make
sure the notch in the switch cup cover of the
light kit fitter clears the reversing switch in
the switch cup. Position the light kit fitter
on the switch cup and turn it clockwise un-
til it locks. Tighten the three serrated head
screws that were loosened in step 1 to se-
cure the light kit fitter (Figure 16).
4. Remove the rubber washer, hex nut, bottom
cover and the finial from the light kit fitter
(Figure 17).
5. With power off, install the two fluorescent
bulbs (Max. 14W, included) by screwing
into the light bulb sockets.
6. Position the glass bowl over the threaded
nipple and pass the fan switch chain through
the side hole in the glass bowl.
7. Re-install the rubber washer and hex nut to
the threaded nipple of the light kit fitter to
secure the glass bowl properly.
8. Re-install the bottom cover and finial and
finger tighten the finial.
CAUTION - Be sure that the fan switch chain
does not make contact with the light bulbs.
Figure 16
9.

Publicidad

Capítulos

Tabla de contenido

Solución de problemas

loading

Este manual también es adecuado para:

433 686435 252433 237435 182

Tabla de contenido