HAMPTON BAY Sibley 52-BRW Manual Del Propietário página 12

10.
Fan Without Light Kit
1. In order to use the fan without the light kit,
remove the switch cup cover from the top
of the light kit fitter by removing the cen-
ter hex nut inside the switch cup cover, and
then thread the switch cup cover off of the
threaded nipple on the top of the light kit fit-
ter. Remove three serrated head screws,
2. Press the plastic plug (provided) into the
center hole of the switch cup cover.
3. Align the three screw holes in the switch cup
cover with the three key slots in the switch
cup. Make sure the notch in the switch cup
cover clears the reversing switch in the
switch cup (refer to figure 16 on page 9).
4. Position the switch cup cover onto the
Figure 17
switch cup and install the three serrated head
screws that were removed in step 1. Turn the
switch cup cover clockwise until it locks and
tighten the three serrated head screws.
YOUR FAN/SWITCH CUP COVER MAY NOT LOOK
EXACTLY LIKE THE ILLUSTRATION, HOWEVER
THE INSTALLATION IS THE SAME.
Figure 18