Ecco REFLEX 5590 Serie Instrucciones De Instalación Y Funcionamiento página 3

Vacuum-Magnet Mount:
The Vacuum-Magnet Mount feature includes suction cups on the
bottom of the minibar, with a magnet inside of the suction cup,
for a secure, temporary mount. The minibar should be placed in
the center of the roof where the least amount of curvature occurs.
Before installing, make sure the mounting surface is clean and
there is no debris on the bottom of the minibar or on the roof of the
vehicle, which could reduce the holding power of the suction cup
and magnet. Place and remove the minibar without sliding to avoid
scratching the paint on the vehicle. After placement, the minibar
should adhere firmly to the surface. If the unit slides or moves easily,
a proper installation has not been obtained. To release the vacuum,
lift the tab to release the airlock (see Figure 4). To protect the
Vacuum-Magnet Mount assembly, return minibar to the box when not
in use. Do not attempt to attach the minibar to an ice-covered
surface.
!
WARNING!
Maximum recommended vehicle speed for safe operation
using the Vacuum Mount model is 65 mph (104 km/h), when
fitted to the center of a vehicle roof of steel construction.
Higher speeds could cause the mount to fail, resulting in the
minibar flying off of the vehicle, which could cause dam-
age to other vehicles, and injury or death to the passengers.
The vacuum-magnet mount is not intended as a permanent
mounting for the minibar. The vacuum-magnet mount unit
must be mounted on a flat smooth magnetic surface (i.e. no
fiberglass, ribbed style roofs, etc.). Ensure that the magnet is
kept clean.
PULL/ROLL TAB UPWARD TO RELEASE VACUUM
!
WARNING!
Failure to follow these instructions can result in fire or injury from excessive heat build up.
Operator is responsible for ensuring auxiliary plug fits correctly into auxiliary power plug outlet used.
For proper operation, verify auxiliary power outlet circuit is rated to supply a minimum of 10 amps. (See specifications section for rated
current in amperes).
Do not exceed the current rating for the auxiliary power outlet recommended by vehicle manufacturer.
Keep auxiliary plug and outlet clean and free of debris.
Do not use the auxiliary plug when wet.
Insert auxiliary plug fully into the outlet for proper connection.
Grasp auxiliary plug, NOT cord, to remove from outlet.
Remove auxiliary plug completely from outlet when light is not in use.
920-4300-00 Rev. D
Figure 4
Magnet Mount Installation for 5590 Series:
1. Refer to the appropriate Vacuum Mount Installation for the 5500
series, steps 2 through 9, and the corresponding Figures for
wiring instructions for the cord.
2. Place hex nut into the hex shaped retaining cavity on the inside
of the minibar base.
3. Place an internal star washer onto the enclosed M5 x 20 hex
bolt and insert the hex bolt through the hole in the cup magnet
as shown. Hold the magnet/bolt assembly with the bolt extended
through the magnet as far as possible and feed the hex nut and
the shank of the bolt through one of the openings at the 4 corners
of the underside of the minibar base. Maintain tension on the
bolt/nut by holding onto the cup magnet while tightening the
assembly. Repeat this process for all four corners.
4. Place the adhesive magnet covers over the magnets.
5. Replace the lens.
PULL/ROLL TAB
UPWARD TO
RELEASE VACUUM
Note: The Magnet Mount is not recommended for use on a mov-
ing vehicle, nor is it inteded as a permanent mount for the light.
Long duration usage of the magnet in the presence of moisture
will cause the steel to rust.
Figure 5
Page 3 of 5