Andis TS-2 Instrucciones De Uso Y Cuidado página 3

4. Never operate this appliance if it has a damaged cord or
plug, if it is not working properly, if it has been dropped or
damaged, or dropped into water. Return the appliance to an
Andis authorized service station for examination or repair.
5. Keep the cord away from heated surfaces.
6. Never drop or insert any object into any opening.
7. Do not use outdoors or operate where aerosol (spray)
products are being used or where oxygen is being
administered.
8. Do not use this appliance with a damaged or broken foil
or cutter, as injury to the skin may occur.
9. Always attach plug to appliance first, then to outlet.
To disconnect, turn all controls to OFF, then remove plug
from outlet.
10. Keep the appliance dry.
11. For the purposes of recharging the battery, only use the
detachable supply unit provided with this appliance.
SAVE THESE INSTRUCTIONS
THIS PRODUCT INTENDED FOR PROFESSIONAL USE
OPERATING INSTRUCTIONS
CHARGING SHAVER
The shaver has not been charged at the factory. Please charge the shaver for
a minimum of 2 hours before the first use for maximum performance.
This battery charger Andis model TS-1 is intended for use with Andis model TS-2
shaver lithium-ion battery with a rated capacity of 3.7V
shaver and AC adapter from the carton. Plug the adapter into a 100-240V AC
outlet, or according to your local power standards. Note that the shaver ON/OFF
switch must be in the OFF position for the battery to charge.
Plug the cord adapter directly into the inlet on bottom of the shaver (Figure A).
The red charging indicator light on the shaver will turn on. After the battery is fully
charged, the red charging indicator light will turn green.
When using the charging stand, plug the cord adapter directly into the inlet on the
2.96 Wh. Remove the
3