Publicidad
Idiomas disponibles
Idiomas disponibles
The sound signal will be stopped
· automatically after 2 minutes and/or by operating
any key. Then the blinking of the timer display stops
and the display extinguishes.
Switching-OFF/changing the timer
· The timer can be changed or switched-off anytime by
simultaneously operating MINUS (2) and PLUS (3) keys.
(with sound signal). The timer will be switched off by
counting down to "0" with the minus-key. For 10 se-
conds the timer display remains at "0" before it will
be switched-off.
Timer programming on cooking zones
When the control is switched- ON an independent ti-
mer can be programmed for every cooking zone.
· By selecting a cooking zone with the cooking-zone-
selectkey (4), then selecting the setting and, finally,
operating MINUS (2) and PLUS (3) keys simulta-
neously, the timer can be programmed as a switch-
off function for a cooking zone.
· During timer programming, the pilot light (6) of the
selected cooking zone blinks.
· When the timer has run down, there is a sound sig-
nal and the timer display shows "00" statically, the
assigned cooking zone timer LED blinks. The pro-
grammed cooking zone will be cut off and „H" will be
displayed if the coking zone is hot.
The sound signal and the blinking of the timer LED
will be stopped
· automatically after 2 minutes
· by operating any key.
The timer display extinguishes.
· The basic behaviour follows the description of the
"minute minder" (stand-alone-timer).
Precautions (Fig. 3)
- When one makes use of heating elements, we advi-
se receptacles with flat bottom having same diame-
ter or lightly higher than that of the hot area.
- Avoid overflows of liquid, therefore when boiling has
happened, or in any case when liquid is heated, redu-
ce the heat supply.
- Don't leave the heating elements on without recep-
tacles on the top or with void pots and pans.
- If the surface of the hob is damaged, immediately
disconnect the appliance from the mains to prevent
the possibility of electric shock.
- Never use a steam cleaner to clean the hob.
- This appliance hood is not designed to be used by
people (including children) with reduced physical,
sensorial or mental capacity, or who lack experience
or knowledge about it, unless they have had super-
vision or instructions on how to use the appliance by
someone who is responsible for their safety.
- Children must be supervised to ensure that they do
not play with the appliance.
Maintenance (Fig. 4)
By means of a scraper immediately remove any allu-
minium foil bits, food spills, grease splashes, sugar
marks and other high sugarcontent food from the
surface in order to avoid
damaging the hob.
Subsequently clean the surface with some towel and
appropriate product, rinse with water and dry by
means of a clean cloth. Under no circumstance should
sponges or abrasive cloths be used; also avoid using
aggressive chemical detergents such as oven sprays
and spot removers.
Installer's Instructions
Installation
These Instructions are for the qualified technician, as a
guide to installation, adjustment and maintenance, ac-
cording to the laws and standards in force. These ope-
rations must always be carried out when the appliance
has been disconnected from the electric system.
Positioning (Fig. 5)
1 Front view
2 Front side
The appliance can be fitted into a working area as
illustrated on the figure. Apply the seal supplied over
the whole perimeter of the working area.
I f once the appliance is installed there is access to
the lower part, a protection panel (wooden or some-
thing similar) ought to be placed at the distance indi-
cated in the figure.
Electrical connection
Prior to carrying out the electrical connection, please
ensure that:
the plant charac- teristics are such as to follow what
is indicated on the matrix plate placed at the bottom
of the working area;
- that the plant is fitted with an efficient earth
connection, following the standards and law
provisions in force.
- The earth connection is compulsory in terms of
the law.
Publicidad
