Troubleshooting; Error Code Display On Led Wire Controller - fluidra AQUASPHERE VSP 17 Manual De Instrucciones

Tabla de contenido

Idiomas disponibles

6.2.5 System reset function

Press

and

6.2.6

Symbol of heating, the light will be on when it is in operation.

When defrosting, the light will flash.

6.2.7

Symbol of automatic stop, the light will be on when it is in operation.

Note: When parameter P6 is on checking/adjusting, Symbol of automatic stop light

6.2.8

Symbol of automatic start, the light will be on when it is in operation.

Note: When parameter P5 is on checking/adjusting, Symbol of automatic start light

6.2.9

Press this button, the light will be flash,

6.2.10

While you choose the Smart, the heat pump will just operate in 'Small output' , 'Medium output' and 'Full output'

When in 'Small output', the lamp of Smart is lighting, the light of Silent will be flash.

When in 'Medium output', the light of Smart will flash.

When in 'Full output', the lamp of Smart is lighting, the lamp of Powerful will be flash.

6.2.11

While you choose the Silent , the heat pump will just operate in 'Medium output' and 'Small output'

When in 'Small output', the light of Silent will flash.

When in 'Medium output', the lamp of Silent is lighting, the lamp of Smart will be flash

7. Troubleshooting

7.1 Error code display on LED wire controller

Malfunction

Inlet water temperature

sensor failure d1-TH6

Outlet water temperature

sensor failure d2-TH5

Heating piping sensor failure

d5-TH2

Ambient temperature sensor

failure d3-TH1

Exhaust piping sensor failure

d6-TH3

in 10s, the system will reset and display "0000" on the controller.

the heat pump will operate in 'Full output' only.

Error

code

1. The sensor in open or short circuit

PP01

2. The wiring of sensor is loose

1. The sensor in open or short circuit

PP02

2. The wiring of sensor is loose

1. The sensor in open or short circuit

PP03

2. The wiring of sensor is loose

1. The sensor in open or short circuit

PP05

2. The wiring of sensor is loose

1. The sensor in open or short circuit

PP06

2. The wiring of sensor is loose

Reason

will be flash.

Solution

1. Check or change the sensor