Assembly Instructions - Real Flame JENSEN Co 142NG Manual Del Propietário

ASSEMBLY INSTRUCTIONS

1.) Place the lava rock or other Real Flame filler material into the burn area by hand. Do
not dump the bag into the burner area, or directly onto the burner to avoid clogging the
burner with dust. Position the filler material across the burn area to a level half an inch
(1/2") above the burner.
If a Real Flame glass filler is being used, first place down a 1.5" layer of the included lava
rock then place the glass filler on top of that layer to a level 1/2" above the top of the
burner. This allows for better air flow below the burner and decreases the amount of
glass filler needed.
Filler Material Warning
1. Do not overfill the burner area with rock or glass filler; use only the specified amount. The total
depth of the filler should not be more than 1/2 inch above the burner tube. Only Real Flame filler
products have been certified and tested for safe use with this fire table. Using other filler material may
result in increased popping and cracking or increased carbon monoxide emissions.
2. Do not light or use this fire table if the filler is wet. Ensure filler is completely dry before lighting.
Intense heat can cause wet filler to explode and hit someone causing injury.
3. Keep away from the fire table for at least 20 minutes during initial start-up as filler could retain
moisture from manufacturing and shipping.
6