Publicidad
Idiomas disponibles
Idiomas disponibles
The maximum length between
post sleeves measured in line with
the guardrail cannot exceed 5 in.
short of full length, depending on
which kit is being used.
Building codes are very specific on
allowable angles and widths. It is very
important to consult with your local building
code officials and plan your stair layout
accordingly. Leave adequate space for
graspable hand rail if applicable.
Note: The slope of the stairs can be 30-37
degrees.
Note: Rail lengths will vary slightly due to
manufacturing processes. Make sure rails
are cut to correct length.
Please visit https://www.fiberondecking.com/resources/installation-instructions or call Consumer and Technical Support at 800-573-8841.
7
HavenView
CountrySide Installation Instructions - 6-ft. and 8-ft. Stair
™
1
Cover 4x4 posts or Fiberon
bracket with post sleeve and verify spacing.
Posts should be plumb in both directions.
Place post sleeve base moulding over post
sleeve and slide it down to the deck surface.
2
Aligning feature
Ensure that the bottom rail is positioned
correctly prior to cutting the bottom rail
angle for installation. The bottom rail has an
aligning feature on the top, which should be
on the yard side of the rail opposite to the
deck side.
3
To establish the stair angle, use a 1x4 or
similar support to bridge at least three stairs.
Place the bottom rail between the stair posts.
The most recent installation instructions can be found on our website.
surface mount
®
Yard Side Deck Side
4
Center the hole pattern between the posts,
allowing a minimum 1-
/
-in. from rail end to
5
8
routed baluster holes.
5
Transfer the stair angle to both ends of the
bottom rail and cut to the required length
and angle. Test for a snug fit and make
corrections as needed.
6
Square Composite Balusters: Transfer the stair
angle to the balusters, and cut the balusters
to desired length.
Note: Round metal balusters are pre-cut on
one end. If a custom angle is required, cut
the factory angled end, leaving the square
end as is. This will allow proper seating
when securing the top of the balusters later
in the installation.
Publicidad
