Stenhoj MASCOT 1.32 Instrucciones De Operacion Y Mantenimiento página 6

5
Note:
Due to the fine and precise tolerances of spindles and nuts, these must be carefully maintained. They must be kept absolutely
clean and should always be well lubricated (cp. lubrication instructions below). If these instructions are ignored, there is a risk
that the spindles will be damaged.
Due to the construction of the safety system they do not require maintenance, however, we recommend that the movable parts
on the top of the posts are greased once every 6 months.
Lubrication:
Lubricate the lift every 6 months as follows:
WHERE
Chain
Roller pipes/guides
Spindles/nuts
Top casing
Suspension for arms
Arm locks
Cleaning of 2-post surface mounted lifts to prevent corrosion damages.
Corrosive fluids as brake fluid, oil, fuel or other solvents must be wiped off immediately, otherwise damage will occur to the
coating.
Special attention must be paid to the corrosive effect of salt in fall and winter periods.
The cleansing agents must not have any abrasive effect, nor contain solvents.
The lift must be cleaned at least once a week.
The lift must be cleaned with a non-corrosive cleansing agent.
Clean and wipe the lift according to the following scheme:
When:
Every week
Stenhøj A/S does not accept any claim concerning the paint peeling off or corrosion damages caused by missing or
insufficient cleaning or maintenance.
Repair of damages:
Repair of damages on the coating must be carried out immediately in order to minimize the extent of the repair.
The damages will typically be:
1. Damages which do not affect the metal surface but affects the coating itself
2. Damages going down into the metal surface.
Repairs:
Contact Stenhøj Autolift A/S for guidance.
Order number for repair paint is to be seen in the spare parts list and contains basic cleanser, primer and paint together with
instructions for repair of paint damages.
Please state RAL number of paint.
MAINTENANCE
HOW
Remove cover plate
Remove steel bands from front
edges of posts
Remove top cover
CLEANING
Where:
Pads
Arms
Carriage
Post
Lithium grease
Lithium grease
Molybdenum grease (apply with
brush)
Lithium grease
Lithium grease
Lubricating oil
How:
Clean and wipe
T60674
WHAT
Remarks: