Napa 85-8100 Manual De Instrucciones página 7

3.3 This NAPA Digital Wheel Charger is for use on a nominal 120-volt circuit and has a grounding
plug that looks like the plug illustrated below (A). A temporary adapter, which looks like the adapt-
er illustrated in (B) and (C), may be used to connect this plug to a two-pole receptacle as shown in
(B), if a properly grounded outlet is not available. The temporary adapter should be used only until
properly grounded outlet can be installed by a qualified electrician.
DANGER: BEFORE USING ADAPTER AS ILLUSTRATED, BE CERTAIN THAT CENTER
SCREW OF OUTLET PLATE IS GROUNDED. The green-colored rigid ear or lug extending from
adapter must be connected to a properly grounded outlet: make certain it is grounded. If neces-
sary, replace original outlet cover plate screw with a longer screw that will secure adapter ear or
lug to cover plate and make ground connection to grounded outlet.
USE OF AN ADAPTER IS NOT ALLOWED IN CANADA. IF A GROUNDING-TYPE RECEPTACLE
IS NOT AVAILABLE, DO NOT USE THIS CHARGER UNTIL THE PROPER OUTLET IS INSTALLED
BY A qUALIFIED ELECTRICIAN.
3.4 An extension cord should not be used unless absolutely necessary. Use of improper extension
cord could result in a risk of fire and electric shock. If extension cord must be used, make sure:
a. that pins on plugs of extension cord are the same number, size, and shape as those of plug
on the NAPA Digital Wheel Charger;
b. that extension cord is properly wired and in good electrical condition;
c. that wire size is large enough for AC ampere rating of charger as specified in the following
table.
AC input rating, amperes
Equal to or
greater than:
12
*American Wire Gauge
Recommended minimum AWG* size for
extension cords for battery chargers
But less than:
25 (7.6) 50 (15.2) 100 (30.5) 150 (45.6)
14 16
▪  ▪
AWG size of cord
Length of cord, in feet (meters)
12 10 8