Check Operation - Whirlpool 3HWED5205SQ0 Instrucciones De Instalación

Check Operation

1. Check that you:
did not skip any steps.
installed all parts.
properly installed dryer legs.
leveled dryer.
have all the tools you started with.
2. Plug power supply cord into grounded outlet or connect
direct wire to power supply. Turn power supply on.
3. Read the Use and Care Guide to fully understand your new
dryer. Select a full heat cycle (not the air cycle) and start
dryer. After five minutes, open dryer door. You should feel
heat inside dryer.
If dryer does not operate properly, check the following:
electrical supply is connected.
house fuse is intact and tight; or circuit breaker has not
tripped.
dryer door is closed.
controls are set in a running or "On" position.
start button has been pushed firmly.
If dryer makes an unusual noise, check that the dryer is level.
10