Olympia PS-35 CC Instrucciones De Uso página 7

Remedying a paper jam
If too much paper is fed into the cutting unit, a paper jam occurs.
Proceed as follows:
Push the sliding switch to the REV position.
-
The cutting unit runs backwards and pushes the excess paper back.
-
Reduce the paper quantity and slide the switch to ON/AUTO again. The cutting unit
-
runs forward again and the paper still in the cutting unit is shredded.
If the backwards and forwards movement does not remedy the paper jam, pull out the
mains plug and remove the remaining paper manually from the cutting unit.
Motor protection
The motor switches off automatically in the event of overloading. Pull out the mains
plug from the socket and allow the motor to cool down to room temperature. Plug the
mains cable back in and then continue operation.
Notes on care and maintenance
Caution: maintenance work may only be performed when the mains plug is pulled
out.
For you to be able to continue using your paper shredder for as long as possible, clear
residual paper from the cutting unit at regular intervals and apply special oil for paper
shredders to the cutting unit. This special oil is available from specialist dealers or
directly from our service centre in Hattingen. This will extend the service life of the
device.
Technical data
Model: PS-35CC
Power supply: 230V / 50Hz
Cutting width: 4 x 40 mm (cross-cut particles)
Cutting power: max. 3 DIN A4 sheets (70 g/m
Security level: 3
Max. power consumption: 0.8 A
Size (W x H x D): 302 x 312 x181 mm
Weight: 3288 g
Device malfunctions
Problem Cause
Device does not Is the mains cable plugged
work properly in the socket?
Is the sliding switch set to
ON/AUTO?
Does the motor not start
when paper is fed in?
Has the device been placed
the right way round and in
the correct position on the
paper collection basket?
2
)
Remedy
Plug the mains cable into the
socket properly.
Set the sliding switch to ON/AUTO.
Push the paper into the infeed slot
so that it touches the sensor in the
centre.
Place the device on properly so
that the contact switch is activated.
Problem Cause
Device does not Was the device in constant
work after lengthy operation for some time?
operation or Is the surface of the device
stops during warm?
operation
Paper jam Have you inserted more
than 3 sheets of paper (70
g/m²)?
Has the paper not been
inserted straight in the
infeed slot?
If you cannot rectify the fault yourself, contact your dealer or call the Olympia hotline.
ATTENTIO N!
INPORTAN T GU AR ANTEE DOCUMENTS
PLE ASE STO RE IN A S AFE PL ACE.
Dear Customer,
Thank you for buying a quality product from
the device should develop a technical problem please observe the following
points:
 The guarantee period for the device is 24 months.
 Make sure that you store the purchasing receipt and the original packaging.
 Should a problem occur, please call our hotline first:
+ 49 (0) 180/500 7514
(Fee for connections outside Germany: additional Euro 0.12
per call for the connection within Germany.)
Our personnel are often able to provide helpful advice over the phone.
 If it is not possible to clear up the problem over the phone, please send the
device back to the following address:
Service-Center Hattingen
Weg zum Wasserwerk 10
45525 Hattingen, Germany
Guarantee repairs will only be performed if the purchase receipt is enclosed with
the device.
Thank you for your understanding.
Yours faithfully,
Your Olympia Business Systems partner
Remedy
Pull out the mains plug from the
socket and allow the motor to cool
down to room temperature.
Set the sliding switch to REV to
push back the paper. Switch the
device to ON/AUTO again to shred
the paper remaining in the cutting
unit.
Guarantee
. In the unlikely event that