Maintenance; Technical Data - Urrea LP807A Manual De Usuario

will get overloaded, resulting in tool malfunc-
tion. The speed adjusting dial can be turned
only as far as 3000 and back to 1000. Do not
force it past 3000 or 1000, or the speed adjust-
ing function may no longer work.
OPERATION
CAUTION: Always wear safety glasses or a
face shield during operation.
Hold the tool firmly. Turn the tool on and then
apply the wool bonnet to the workpiece.
In general, keep the
wool bonnet at an
angle of about 15
degrees to the work-
piece surface. Apply
slight pressure only.
Excessive pressure
will result in poor
performance and premature wear to wool
bonnet.

MAINTENANCE

BEFORE ALL CARE AND MAINTENANCE WORK
• Turn the machine off.
• Wait until the machine has come to a com-
plete standstill.
• Pull out the power plug.
CLEANING
Clean the machine with a moist cloth and some
soft soap. Do not use any detergents or solu-
tion; these may cause corrosion of the plastic
parts of the machine. Make sure that no water
reaches the inside of the machine.
Keep the vent passage clear from dirt, clean off
the accumulated dust and oil dirt periodically.
SERVICING
There are no parts on the inside of the machine
which require maintenance by the user. Should
the machine fail to function after a long opera-
tion time, have it checked by a technician.
REPLACEMENT PARTS
Danger of accident! Parts which were not re-
viewed and approved by the manufacturer can
damage the machine and can cause serious in-
juries. Use only original parts for replacing old
parts, particularly for safety mechanisms and
cutting tools.
E N G L I S H •
CARBON BRUSH
The brushes should be checked periodically
and worn-out brushes should be replaced in
time. After replacing, inspect whether the new
brushes can move freely in the brush holder.
Keep running the motor for 15 minutes to
match the contact of the brushes and commu-
tator.

TECHNICAL DATA

VOLTAGE-FREQUENCY
NO LOAD SPEED
PLATE CAPACITY
POWER
POWER CONSUMPTION
WEIGHT
U se r's m a nua l
120 V ~ 60 Hz
(1 000 - 3 000) r/min
7" (177,8 mm)
1 300 W
0,55 kWh
3,4 kg (7,4 lb)
11