Profile CAMBIARE PAC-353 201100002 Adendo Al Manual Del Usuario página 25

PROGRAMMING (MULTIPLE) PUSH BUTTON(S)
Press and hold the "+" key.
Slide the switch from OFF to ON.
The bell will emit a short, two-tone signal.
TIP : When there is interference, or if your bell stops responding to the push button, remove the
batteries from both devices and follow the steps below.
WARANTY AND DAMMAGE
The guarantee period for the PAC-353 amounts to two years and commences on the date of
purchase. During this guarantee period Eltra nv will repair any defects attributable to material or
production faults. Eltra nv may choose to either repair or replace a defective appliance.
Eltra nv is not obliged to repair or replace appliances if they have become defective as a result of
damage, inappropriate use, or modifications or adaptations made after the purchase date.
Take any defective appliance together with the original receipt back to the shop where the appli-
ance was sold. Always add a note with a description of the problem.
Eltra nv can under no circumstances whatsoever be held responsible for damage of whatever na-
ture if the appliance was not correctly installed according to the specified installation instructions,
nor for damage as a result of unforeseen circumstances such as natural disasters, lightning strike,
etc. All such resulting costs are consequently at the expense of the buyer and are not covered by
the guarantee conditions.
ON
O FF
O N
O F F
Ref. 201100002
Art. PAC353
www.profile.eu
Profile, Pachtgoedstraat 2,
B-9140 Temse, Belgium
MAX 4
Press within 30 seconds (or until the blue light
stops flashing). The doorbell will emit a tone.
The push button is now installed.
R&TTE APPROVED - 433MHz
Eltra nv, Pachtgoedstraat 2, 9140 Temse, Belgium,
hereby declares that the product : PAC353 - 201100002
is in compliance with the essential requirements and
other relevant provisions of Directive R&TTE 1999/5/
EC.The original declaration of conformity can be re-
quested at info@eltra.be
UK