Remote Control Operation; Testing Your Fan - Craftmade ELLINGTON Triad TRI54BNK3 Guia De Instalacion

12. Remote Control Operation.

HI button - turns fan to HIGH speed
MED button - turns fan to MEDIUM speed
LOW button - turns fan to LOW speed
OFF button - turns fan OFF
button - controls LIGHT function: turns light
ON/OFF when tapped quickly. Pressing and
holding button down for more than 0.7
seconds converts it into a dimmer. Auto resume
capability keeps light at same brightness level as
the last time it was turned off.

13. Testing Your Fan.

It is recommended that you test fan before finalizing
installation. Locate ON/OFF slider switch on wall
control and set to the ON position. Test light and
dimmer function and then test fan speeds. Next, locate
remote control transmitter. Test fan speeds with the
different fan speed buttons on remote control. Test the
light ON/OFF function with the
remote control. Test dimmer function by holding down
the button for more than 2 seconds. (diagram 1) If
the remote control operates all of the functions of the
fan and light, battery has been installed correctly. If fan
and/or light do (does) not function, please refer to
"Troubleshooting" section to solve any issues.
Turn fan completely off before moving the reverse
switch (located on top of motor housing). Set reverse
switch to recirculate air depending on the season:
- LEFT position in summer (diagram 2)
- RIGHT position in winter (diagram 3)
A ceiling fan will allow you to raise your thermostat
setting in summer and lower your thermostat setting in
winter without feeling a difference in your comfort.
Important: Reverse switch must be set either
completely to the LEFT or completely to the RIGHT for fan
to function. If the reverse switch is set in the middle
position (diagram 4), fan will not operate.
NOTE: If the remote control interferes with other
appliances, change code switches on the transmitter to
another code. If you do change the code, turn power
off first, remove the battery cover and lift the battery
out of the compartment. After setting the new code, go
back to the instructions in the last paragraph of
Section 10 (page 9).
button on the
page 10
motor
housing
(topside)
reverse switch
diagram 1
diagram 2 diagram 3
wall remote control
control transmitter
diagram 4