BEA SC 55/2-SPEED Instrucciones Funcionamiento página 28

Applying the screw belt
This tool can be used with the following screw sizes.：
Screw Length Adjust Knob
Scale
28
d(mm)
L(mm) 25 30/32 35 40 45 50 55
Screw Length
Press
Φ3,5 Φ4,5mm
~
Adjust the scale of the nose piece
1.
to the length of the screw
to be used. Do this before the
screw belt is loaded.
2. Hold down the upper knob on
the feed attachment.
Then move the nose piece to the
point on the scale indicating the
requested screw length to be used.
3. Feed the screw belt into the belt-feed
Guide to the point the first screw is
still outside the nose piece. See fig. on
the left. The first push to the work
surface will feed the screw into the
centre of the nose piece.
Then the bit will push the screw into
the work surface.